Add a Serial port to the MIPS Linkstation
The console is the text output device for system administration messages. These messages come from the kernel, from the init system and from the system logger. On modern small computers the console is usually the computer's attached monitor and keyboard. The LinkStation, however, doesn't have monitor output; instead, it uses a serial connection for console output. Not only does the serial console provide valuable debugging output, it also allows root access!
- (1)Electronic-grade soldering iron (think really small)
- (1) 0.015", 1 oz solder
- (1) 0.1” series PCB header plug, 4-pin
- (1) Serial converter (or build your own - see Stage 4)
Stage 1 - Access the Board
- Disassemble the LinkStation.
- Remove the main circuit board by removing the 4 mounting screws:
- Place the circuit board on a static-free work area:
Stage 2 - Attach Header to the Board
- The console header needs to be attached to the J1 pad:
- Remove the preexisting solder from J1:
Stage 3 - Enable Full Serial Tx/Rx
To enable write support across the serial port, simply bridge R186.
Stage 4 - The Serial Converter
The serial port signals from the processor are only 3.3V. For proper RS-232 12V signaling, an RS-232 level shifter needs to be added. These are very common in PDA serial cables also, but can be purchased from SuperDroid Robots (#MCU-026-172) or CompSys (#A232DBH3v).
- As an alternative you can make the level shifter cable yourself:
- Components can be found at e.g. Digikey
- If you want to build your own serial converter, you will need the following parts:
- (5) 0.1 uF tantalum capacitors
- (1) MAX3232CPE IC (Maxim), 3V type, 16 pin DIL
- (1) RS232 male socket
- (1) Some perf board (about 1" x 1")
- (1) Wire
You can etch a circuit board which makes building the interface and installing the interface really easy. Instructions are Here.
This should be attached as close as possible to the board. The signals are very weak and wires as short as 2" (5 cm) have been reported to cause data loss across the serial port.
Stage 5 - Using the Serial Console
- You may access the serial console using Windows HyperTerminal (included with Windows) or [TeraTerm Pro].
Serial Port Settings