Difference between revisions of "Add a default route"

From NAS-Central Buffalo - The Linkstation Wiki
Jump to: navigation, search
 
Line 16: Line 16:
  
 
After doing this i was able to ping to my heart's content and the apt-get etc worked seamlessly.
 
After doing this i was able to ping to my heart's content and the apt-get etc worked seamlessly.
 +
::<font color=red>Note</font>: This routing information will be lost after rebooting. If you want to have this route added every time you start, edit /etc/network/interfaces and make sure there's a line
 +
gateway 192.168.0.1
 +
at the end of this file.
  
  

Latest revision as of 19:49, 4 August 2006

This article Based on work by frontalot. Originally by Justin Adie. at Linkstationwiki.org
In following the Articles/GeneralFreeLinkTutorial article I got stalled after configuring the IP and DNS resolution etc just before being able to install samba and webmin.

After a bit of tinkering i found that this was because the only route that the LS had was a loopback - I was never getting the request out into the Internet.

easily solved: install a default route. Assuming your router is at 192.168.0.1 you would execute the following commands at the shell:

su
route add default gw 192.168.0.1

After doing this i was able to ping to my heart's content and the apt-get etc worked seamlessly.

Note: This routing information will be lost after rebooting. If you want to have this route added every time you start, edit /etc/network/interfaces and make sure there's a line
gateway 192.168.0.1

at the end of this file.


Some other gotchas: when i installed and ran webmin i forgot to change the IP hosts allowed configuration. it seems to default to a single host. the next time i logged on it denied me access. this can be changed in the /etc/webmin/miniserv.conf text file. i did so thus:

ed /etc/webmin/miniserv.conf
1,$s/allow=192.168.0.x/192.168.0.y/
.
w
q

The first line fires up the EDitor and reads in the miniserv web config file. The second line is a substitution command. 192.168.0.x is the old IP address and .y the new ip address (the 1,$ tells ed to search from the first line to the last).

the "." takes ED out of command mode.

the "w" writes the changes from the buffer to the file.

the "q" quits the editor.


if you just want to check the old IP address you can use the ed command "1,$l" and pick up the address from the "allow=" line.

Originally by Justin Adie and edited by frontalot from linkstationwiki.org