Brick

From NAS-Central Buffalo - The Linkstation Wiki
Revision as of 04:14, 18 July 2006 by 67.162.30.158 (Talk)

Jump to: navigation, search

Some of this information from kuroboxwiki:Brick

Kurobrick.png
WARNING!

There is a possibility that you could brick your NAS with these instructions. Please make sure that you read the entire page carefully.


In the context of LinkStation hacking to brick a LinkStation means to render the LinkStation unusable. A bricked LinkStation does not boot any more, does not respond to requests (e.g. for serving data via Samba), enters EM Mode, and/or does cyclic reboots.

Effectively, the LinkStation is just a brick, which can only be used as a door stopper.

Improper Flash

There have been cases of users writing uploading an incompatible flash image. Please be sure of what you are doing, and be very careful when attempting to modify the contents of the flash memory.

It regularly happens that an LS is diagnosed as bricked, when it isn't. The most common error is to not follow the flashing or installation instructions and still leave some software firewall in place during install.

Fixing a Bricked LS

Re-animating a bricked LS depends on what whent wrong or what was done wrong. Sometimes re-flashing the original or a hacked firmware & OS can help (see Articles/GeneralFirmwareFlash, Articles/GeneralManualFlash. Sometimes it is necessary to physically open the LS, connect the disk to a PC and re-image the drive. See Articles/GeneralRescueGuide for instructions.

Linkstations/Kuroboxes that have been bricked due to bad flash memory contents can be restored by rewriting the flash memory with the correct contents. However, since the device can not be booted, this requires the use of JTAG.