Difference between revisions of "Debian hdd spindown"

From NAS-Central Buffalo - The Linkstation Wiki
Jump to: navigation, search
(Added link to Hard Drive)
Line 14: Line 14:
edit /etc/init.d/sysklogd and set SYSLOGD to
edit /etc/init.d/sysklogd and set SYSLOGD to
  SYSLOGD="-m 0"
  SYSLOGD="-m 0"
[[Category: Debian]]

Revision as of 01:55, 10 July 2006

If you're not using your Kurobox 24 hours a day, it could be good to allow the hard drive to spin down and reduce noise and power usage. For this you'll need to install hdparm to tune the sleep delay, and configure syslog to prevent it from writing to the disk, causing it to wake up every 20 minutes!

Install & Configure hdparm

  • Installation
apt-get install hdparm
  • Configuration
nano /etc/hdparm.conf

and uncomment the lines about /dev/hda at the end of the file, then add

spindown_time = 240

between the brackets. 240 means 240*5 seconds = 20 minutes idle before spinning down ;)

Modify syslogd Configuration

If you do not do that, your HDD will be turned on every 20 minutes because syslog will log a "MARK" in /var/log/messages every 20 minutes. So we need to remove that marking : edit /etc/init.d/sysklogd and set SYSLOGD to

SYSLOGD="-m 0"