Difference between revisions of "Disassemble the LS MINI"

From NAS-Central Buffalo - The Linkstation Wiki
Jump to: navigation, search
m (References)
Line 48: Line 48:
<References \>
<References />

Revision as of 15:11, 9 September 2008

Linkstation Mini Back

This information and pictures from this thread[1] and Yamasita's site too[2]


Pop Open Case

Take the top off

The LinkStation Mini case turned out to be pretty easy to take apart.

  • Using 1 inch flexible putty knife.
  • There's a slot in the top case between the USB port and the Ethernet port.
  • Insert the putty knife 1/4 inch, and then rotate the knife to lever the back of the case out, so that the top of the case can be pulled up.
  • Then Carefully remove the top case.

Take off Side rails

Take off side rails

There are no screws or tape or anything, it's just the parts you see here. The aluminum side rails have little bumps that hook into the drives where the screws would normally go.

After removing top cover all you need is to gentle pull these side rails.

All done

All done

If you detach the drives from the motherboard be sure to remember which one goes where.

If you swap them by mistake it doesn't appear to cause damage.

All that happens is that the LinkStation doesn't boot.

Swapping them back seemed to make everything work again.

Front side of Board

LS MINI PCB frontside - high resolution
  • In The middle, Marvel 88F5182-A2 C400. 400MHz ARM Processor.
  • To the left, NANYA NT5TU32M16AG-3C. 512Mb DDR2 SODIMM two in 128 MB.
  • Marvell 88E118-NNC1. Gigabit Ethernet Controller

Back side of board

LS MINI PCB backside - high resolution
  • NANIYARA SST 39VF020. 256K x8CMOS Multi-Purpose Flash


  1. The Buffalo NAS hacking Forums:Low-quality pictures of Linkstation Mini board
  2. 分解 (disassemble)- LS-WSGL/R1