Difference between revisions of "FreeLink for the LinkStation Quad"

From NAS-Central Buffalo - The Linkstation Wiki
Jump to: navigation, search
(Created page with 'This page will describe the steps taken to get FreeLink and subsequently Lenny on my newly acquired Quad. Think of it as work in progress until I actually get Debian on it. And a…')
 
Line 1: Line 1:
This page will describe the steps taken to get FreeLink and subsequently Lenny on my newly acquired Quad. Think of it as work in progress until I actually get Debian on it. And at the same time, any comments or suggestions are very welcome.
+
{{Articles|FreeLink|Debian|LSQuad}}
 +
 
 +
{{brick|}}
 +
 
 +
This page will describe the steps taken to get FreeLink and subsequently Lenny on my newly acquired [[:Category:LSQuad |LS-QL/R5]]. Think of it as work in progress until I actually get Debian on it. And at the same time, any comments or suggestions are very welcome.
  
 
== High Level Steps ==
 
== High Level Steps ==

Revision as of 02:37, 12 March 2010


Kurobrick.png
WARNING!

There is a possibility that you could brick your NAS with these instructions. Please make sure that you read the entire page carefully.



This page will describe the steps taken to get FreeLink and subsequently Lenny on my newly acquired LS-QL/R5. Think of it as work in progress until I actually get Debian on it. And at the same time, any comments or suggestions are very welcome.

High Level Steps

  1. Resize partitions (optional)
  2. Open up for telnet
  3. Install FreeLink image
  4. Configure for Debian
  5. Upgrade to Lenny
  6. Final customization
  7. Backup the changes

Hardware

Model LS-QL
Disks
  • 1 x 1TB Seagate Barracuda 7200.12
  • 3 x 1TB WS Caviar Green
Firmware 1.11

Software

  • ACP Commander
  • FreeLink image
  • Debian tarball