FreeLink for the LinkStation Quad
From NAS-Central Buffalo - The Linkstation Wiki
(Difference between revisions)
| Line 3: | Line 3: | ||
{{brick|}} | {{brick|}} | ||
| - | This page will describe the steps taken to get FreeLink and subsequently Lenny on my newly acquired [[:Category:LSQuad |LS-QL/R5]]. Think of it as work in progress until I actually get Debian on it. And at the same time, any comments or suggestions are very welcome. | + | This page will describe the steps taken to get FreeLink and subsequently Lenny on my newly acquired [[:Category:LSQuad |Quad (LS-QL/R5)]]. Think of it as work in progress until I actually get Debian on it. And at the same time, any comments or suggestions are very welcome. |
== High Level Steps == | == High Level Steps == | ||
| Line 12: | Line 12: | ||
# Upgrade to Lenny | # Upgrade to Lenny | ||
# Final customization | # Final customization | ||
| - | # Backup the changes | + | # Backup the changes (while not technically needed, this is '''highly''' recommended) |
== Hardware == | == Hardware == | ||
| Line 33: | Line 33: | ||
* FreeLink image | * FreeLink image | ||
* Debian tarball | * Debian tarball | ||
| + | |||
| + | |||
| + | == Resizing the partitions == | ||
Revision as of 02:40, 12 March 2010
|
This page will describe the steps taken to get FreeLink and subsequently Lenny on my newly acquired Quad (LS-QL/R5). Think of it as work in progress until I actually get Debian on it. And at the same time, any comments or suggestions are very welcome.
Contents |
High Level Steps
- Resize partitions (optional)
- Open up for telnet
- Install FreeLink image
- Configure for Debian
- Upgrade to Lenny
- Final customization
- Backup the changes (while not technically needed, this is highly recommended)
Hardware
| Model | LS-QL |
|---|---|
| Disks |
|
| Firmware | 1.11 |
Software
- ACP Commander
- FreeLink image
- Debian tarball
