FreeLink for the LinkStation Quad

From NAS-Central Buffalo - The Linkstation Wiki
Revision as of 02:40, 12 March 2010 by Peterhoeg (Talk | contribs)

Jump to: navigation, search


Kurobrick.png
WARNING!

There is a possibility that you could brick your NAS with these instructions. Please make sure that you read the entire page carefully.



This page will describe the steps taken to get FreeLink and subsequently Lenny on my newly acquired Quad (LS-QL/R5). Think of it as work in progress until I actually get Debian on it. And at the same time, any comments or suggestions are very welcome.

Contents

High Level Steps

  1. Resize partitions (optional)
  2. Open up for telnet
  3. Install FreeLink image
  4. Configure for Debian
  5. Upgrade to Lenny
  6. Final customization
  7. Backup the changes (while not technically needed, this is highly recommended)

Hardware

Model LS-QL
Disks
  • 1 x 1TB Seagate Barracuda 7200.12
  • 3 x 1TB WS Caviar Green
Firmware 1.11

Software

  • ACP Commander
  • FreeLink image
  • Debian tarball


Resizing the partitions