FreeLink for the MIPSel (LS2) LinkStation

From NAS-Central Buffalo - The Linkstation Wiki

Revision as of 02:18, 14 August 2006

WARNING! There is a possibility that you could brick your NAS with these instructions. Please make sure that you read the entire page carefully.

Freelink for the MIPS.

This has been packaged up as a image.dat suitable for flashing.

From the Forums:

• Freelink for the mips - Testers required

Refer to The LinkStation firmware flasher article for Firmware Updater HowTos.

Info about this

Freelink download

• image.dat password = 1NIf_2yUOlRDpYZUVNqboRpMBoZwT4PzoUvOPUp6l (As required by the firmware updater)
• It has a static IP assigned to 192.168.11.150
• root password = "freelink"
• ssh enabled (no telnet as default)

avr_evtd ver 1.61 - Fully functioning including s/w shutdown/restart, emergency telnet on port 1234 (just two clicks of the reset button).

Note: The operation of the reset button for the avr_evtd daemon has changed. This now, with proper setup, allows the user to enter EM-Mode. Please refer to AVR watch-dog daemon for Linkstation for more information.

Installed applications:

gcc
libc-dev
libc6-dev
make
nano
avr_evtd
ssh

Good luck all! -User:SpannerInTheWorks