Hardware Hacks for the LS Pro
From NAS-Central Buffalo - The Linkstation Wiki
All input is welcome. Please do not edit this page directly as I do not want any information to get past me without my knowledge as it could be detrimental to the LS Pro on which I'm experimenting. Please post any comments to the forum thread or the talk page.
This is an account of the attempts of Tampakuro (aka Kuroguy) to open the LS Pro hardware to more development. I'll be concentrating mainly on the flash memory as well as adding an eSATA port.
There are two obvious routes to reprogramming the flash memory:
The Dual flash Method
The JTAG Access Method
Adding an additional hard driveAdding a second SATA drive to your Linkstation Pro is as simple as installing a 0.01 uF surface mount capacitor at C279, C280, C281, and C282 and then installing the proper Molex connector at CN8.
To test this I plugged the hard disk into the new sata port (I didn't have a spare SATA drive). The bootloader would not boot directly to the SATA drive plugged into CN8 so I bbooted the device using TFTP to retrieve the kernel and initrd. Once the device had the kernel and initrd loaded it pivoted to the root filesystem on the SATA drive even though it was attached to the secondary SATA port. I have attached a portion of the DMESG showing the device was recognized:
...o Checksum offload enabled o Loading network interface ** egiga_init_module (0) 'eth0' Intergrated Sata device found scsi0 : Marvell SCSI to SATA adapter scsi1 : Marvell SCSI to SATA adapter Vendor: WDC Model: WD2500JS-00NCB1 Rev: 10.0 Type: Direct-Access ANSI SCSI revision: 03 SCSI device sda: 488397168 512-byte hdwr sectors (250059 MB) SCSI device sda: drive cache: write back SCSI device sda: 488397168 512-byte hdwr sectors (250059 MB) SCSI device sda: drive cache: write back sda: sda1 sda2 sda3 sda4 Attached scsi disk sda at scsi0, channel 0, id 0, lun 0 Attached scsi generic sg0 at scsi0, channel 0, id 0, lun 0, type 0 physmap flash device: 400000 at ff800000 CFI: Found no phys_mapped_flash device at location zero....
The next step after installing the SATA connector is to place the board back into the metal chassis and mark the location of the new opening that must be cut to allow access to the connector from the outside of the case. A dremel tool works well for cutting the chassis. After cutting the hole into the chassis, place the chassis into the plastic case and use a hot pin to mark the corners of the opening in the plastic case. Heat the pin sufficiently to poke completely through the case and then use a hot blade to connect the dots you just made in the case. I've found that a razor knife's blade heated with a torch will cleanly cut through the plastic case.