LS Mini: Add a JTAG port
From NAS-Central Buffalo - The Linkstation Wiki
Revision as of 08:57, 24 September 2009 by Pabr (Instructions for adding a JTAG port to the LS MINI)
- Add a 10-pin JTAG connector at the pads labeled CN7. The pin numbering is the same as CN3 on Install_a_JTAG_Port.
- Bridge TMS at the two pads labeled C227 on the top side, near the CPU.
- Bridge TDO under C25 on the bottom side, near CN7.
Open On-Chip Debugger > reset JTAG tap: feroceon.cpu tap/device found: 0x07926041 (mfg: 0x020, part: 0x7926, ver: 0x0) JTAG Tap/device matched > halt target state: halted target halted in ARM state due to debug-request, current mode: Supervisor cpsr: 0x800000d3 pc: 0x00f3aac0 MMU: disabled, D-Cache: disabled, I-Cache: enabled > flash probe 0 Flash Manufacturer/Device: 0x00bf 0x00d6 flash 'cfi' found at 0xfffc0000 > dump_image currentcontents.bin 0xfffc0000 0x40000 dumped 262144 byte in 156.199112s
- This procedure has been tested on only one unit. Someone please confirm.
- Writing to the flash with JTAG has not been tested.
- Bridging C228 instead of C227 activates another JTAG target with ID 0x5182 instead of 0x7926. One pin is probably JT_TMS_CPU and the other JT_TMS_CORE (from the Marvel 88F5182 datasheets). Apparently both cannot be active simultaneously.