Difference between revisions of "Manually flash the LinkStation's firmware"

From NAS-Central Buffalo - The Linkstation Wiki
Jump to: navigation, search
Line 18: Line 18:

Revision as of 07:42, 17 July 2006

This article Based on work done by frontalot at Linkstationwiki.org


There is a possibility that you could brick your NAS with these instructions. Please make sure that you read the entire page carefully.

Different Architectures | This method can be applied to all versions of the LinkStation. Simply substitute the appropriate flash bank for /dev/fl1.

1. Do not manually flash your firmware unless you are absolutely sure about what you're doing! You should read the flash ROM analysis at LinkStation Information before proceeding.

2. You will need the firmimg.bin of your desired firmware. Copy firmimg.bin to your LinkStation.

3. Open up an SSH or telnet session to the LinkStation. Copy firmimg.bin to the /dev/fl1 flash bank:

cat firmimg.bin > /dev/fl1

4. The LinkStation LEDs will begin flashing red; this is normal! The flash process may take several minutes. Absolutely do not turn off the LinkStation, terminate the SSH/telnet session, or in any other way interrupt the flash process. The LEDs will return to normal when the flash process is complete.