Manually flash the LinkStation's firmware
From NAS-Central Buffalo - The Linkstation Wiki
(Difference between revisions)
m |
m |
||
| (6 intermediate revisions not shown) | |||
| Line 1: | Line 1: | ||
| - | {{Template:Articles}} | + | {{Template:Articles|Hacking}} |
| - | + | <font color=red><small>This article Based on work done by frontalot at Linkstationwiki.org | |
| - | This article Based on work done by frontalot | + | |
| - | at Linkstationwiki.org | + | |
</small></font>''<br> | </small></font>''<br> | ||
| - | {{brick|}} | + | {{brick|this is '''ONLY''' applicable to the PowerPC HD-HLAN (LS1). All subsequent models of the LinkStation use the mtd block mapped flash device because the kernels have moved beyond 2.4.17.}} |
| - | + | {{Warning| This is really just background information and only advanced users should be poking around in the flash as this could result in being the proud owner of a toaster. Do not manually flash your firmware unless you are absolutely sure about what you're doing! You should read the flash ROM analysis at: [[LS Hardware and Software information]] before proceeding. This is for changing the EM mode load only, and this shouldn't be used for changing the firmware. [[The LinkStation firmware flasher ]] would be the way to go usually. }} | |
| - | 1 | + | 1. You will need the firmimg.bin of your desired firmware. Copy firmimg.bin to your LinkStation. |
| - | + | ||
| - | + | ||
| - | + | ||
| - | + | ||
| + | 2. Open up an SSH or telnet session to the LinkStation. Copy <tt>'''firmimg.bin'''</tt> to the <tt>'''/dev/fl1'''</tt> flash bank: | ||
cat firmimg.bin > /dev/fl1 | cat firmimg.bin > /dev/fl1 | ||
| - | + | 3. The LinkStation LEDs will begin flashing red; this is normal! The flash process may take several minutes. <font color=red>'''Absolutely do not turn off the LinkStation, terminate the SSH/telnet session, or in any other way interrupt the flash process.'''</font> The LEDs will return to normal when the flash process is complete. | |
| - | + | ||
| - | + | ||
| - | + | ||
| - | + | ||
| - | + | ||
| - | + | ||
Latest revision as of 19:07, 6 September 2006
This article Based on work done by frontalot at Linkstationwiki.org
|
|
1. You will need the firmimg.bin of your desired firmware. Copy firmimg.bin to your LinkStation.
2. Open up an SSH or telnet session to the LinkStation. Copy firmimg.bin to the /dev/fl1 flash bank:
cat firmimg.bin > /dev/fl1
3. The LinkStation LEDs will begin flashing red; this is normal! The flash process may take several minutes. Absolutely do not turn off the LinkStation, terminate the SSH/telnet session, or in any other way interrupt the flash process. The LEDs will return to normal when the flash process is complete.
