Difference between revisions of "Performance tuning the network controller (MTU)"

From NAS-Central Buffalo - The Linkstation Wiki
Jump to: navigation, search
Line 28: Line 28:
  
 
[[Category:General]]
 
[[Category:General]]
 +
 +
[[Category:Hardware]]

Revision as of 07:12, 17 July 2006

This article Based on work by tklee, briand, frontalot, and nix. Originally by frontalot. at Linkstationwiki.org

  • Every time you send a 1500 size packet out on a MTU1492 network you end up with two packets: 1492 + 8. That's why the speed drops - The second packet is almost empty! If you type:
ifconfig eth0
  • It will show:
MTU = 1500
  • The standard MTU[1] for DSL and cable is 1492 maximum, for DSL via PPPoE[2] it is often 1480 (you best ask your provider for the correct value). You can:
  • Add the following line to one of your startup files in the start section, e.g. in
/etc/init.d/networking
/sbin/ifconfig eth0 mtu 1492
OR
  • Add "mtu 1492" (a line by itself) to
/etc/network/interfaces
  1. :maximum transmission unit
  2. :Point-to-Point Protocol Over Ethernet