Serial port
From NAS-Central Buffalo - The Linkstation Wiki
(Difference between revisions)
m (→Buy a TTL/RS232 or TTL/USB interface) |
m (→Buy a TTL/RS232 or TTL/USB interface) |
||
| Line 71: | Line 71: | ||
* $0.17 - [http://www.futurlec.com/Connectors/POLHDCON4.shtml Futurelec: POLHDCON4 - 4 Pin .100" Polarized Header Connector] | * $0.17 - [http://www.futurlec.com/Connectors/POLHDCON4.shtml Futurelec: POLHDCON4 - 4 Pin .100" Polarized Header Connector] | ||
* $0.60 - [http://www.futurlec.com/Connectors/PLHDPIN.shtml Futurelec: PLHDPIN - Crimp Pin for Header Connector] | * $0.60 - [http://www.futurlec.com/Connectors/PLHDPIN.shtml Futurelec: PLHDPIN - Crimp Pin for Header Connector] | ||
| + | * $0.55 - [http://www.futurlec.com/Connectors/DSUBSCF9.shtml Futurelec: DSUBSCF9 - 9 Contact Female Solder Cup Connector] | ||
| + | |||
</small> | </small> | ||
|| | || | ||
Revision as of 05:14, 4 October 2007
Model Specific Directions
| How to add Serial Access | |||||
|---|---|---|---|---|---|
| LS1 | HD-HLAN v1 | For the LS1 | |||
| KURO/HG | KUROBOX | For Kuro/HG | |||
| HG | HD-HGLAN | For the HG | |||
| LS2 | HD-HLAN v2 | For the LS2 | |||
| LSPRO | LS-GL | Use Bottom Slot | |||
| KUROPRO | KUROBOX Pro | ||||
Level Shifter
Build your own TTL/RS232 or TTL/USB interface
- TTL/RS232 - Building a Custom Serial Interface
- TTL/USB - Use a cheap phone sync cable with the serial port
Buy a TTL/RS232 or TTL/USB interface
| The cheapest TTL/RS232 converter uses a MAX232 with two serial channels for standard TTL 3V input. | The cheapest TTL/USB converter uses a chip by FTDI (the same chip is used in the SCON-KIT ) |
|---|---|
| | |
| This board is made by Futurelec, however the order is shipped from Thailand so it takes 2-3 weeks to get it.
You'll also need some headers and connectors | This cable is made by FTDI, but the pinout at the connector end would need to be reassigned. Spec Sheet w/ pinout, wire colors & other info |
|
|
|
| Others | Others |
|
|
|


