Upgrade (or replace) the existing LinkStation hard drive
From NAS-Central Buffalo - The Linkstation Wiki
|Line 35:||Line 35:|
Revision as of 03:47, 28 June 2006
An easier method | You don't need to do any of the following if you run the firmware updater; it will automatically create the necessary partitions. When you boot the LS up for the first time, the disk full LED will flash, this is the LS creating the partitions, wait until the flashing stops, then run the firmware update (you may need to run it twice as the first may fail). The following instructions are intended for people who wish to preserve their existing data.
1. Start by making a backup of your existing hard drive. See Articles/GeneralBackup for instructions on how to perform a backup.
3. Now you need to partition the hard drive according to your needs (replacing "x" with whatever letter you have installed the hard drive as):
4. The standard LinkStation setup uses 3 partitions, hda1 (main ~ 400MB), hda2 (swap ~ 300MB), and hda3 (mount ~ remaining). If you want a larger main partition you should do so at this time. Restore your backup:
dd if=/mnt/whatever/hda1.bin of=/dev/hda1
5. You must run fix_ext2_magic, check for errors, and resize the backup image if you created a larger main partition:
./fix_ext2_magic --fix /dev/hdx1 e2fsck /dev/hdx1 resize2fs /dev/hdx1
6. You may have to use the force option (-f) if resize2fs complains about not running e2fsck. Next create the ext2 filesystem and swap partition. You can turn off drive checking since we are using ext2 with journaling:
mke2fs -j /dev/hdx3 tune2fs -c0 -i0 /dev/hdx2 mkswap /dev/hdx2
7. Place the hard drive in the LinkStation and reboot. Be patient as the first boot may take longer than normal.
Some of this information courtesy of http://www.geishuettner.de/docs/Linkstation/.