From NAS-Central Buffalo - The Linkstation Wiki
Building a 832 push pull amp from scratch. here's some pictures:
Here's the layout of the major components on paper. Next I'll start cutting the aluminum panel.
The 832a dual beam pentode with the 12at7 dual triode (first stage) next to it.
Just starting drilling on the chassis The panel came with those deep scratches in it. If I can't get them out I'll paint the panel black.
The chassis with the transformers and terminals mounted. check out the finish on the panel.
The completed chassis. Time to start cutting some wood.
The completed chassis with the wood frame. still need to sand and round over the edges of the wood.
The completed chassis with the wood frame and mostly polished panel. still need to do something to finish the wood.
you can see the layout of the major components from the bottom and all those tapped holes in the panel. just need to start installing components now.
More wiring done. Still need to wire the filaments, build the time delay relay, and some minor work on the amp.s power stage.
Still need to lacquer the wood, and am waiting for 5 resistors to arrive, but here's a picture of the amp with the tubes installed.
Just needs the filament wiring/transformer and time delay relay board.